<div dir="ltr"><div>Here is another suboptimail behaviour from SMART. <br></div><div><br></div><div>When running -H (health) on the disk with bad blocks, I get:</div><div><br></div><div>=== START OF READ SMART DATA SECTION ===<br>SMART overall-health self-assessment test result: PASSED</div><div><br></div><div>That means that the disk is good, right?</div><div><br></div><div>But, when running with -a, I get these:</div><div><br></div><div>1 Raw_Read_Error_Rate 0x000f   077   064  006 Pre-fail  Always - 51921114<br>7 Seek_Error_Rate         0x000f   077   060   045 Pre-fail  Always - 52739087</div><div><br></div><div>Way too many read and seek errors.</div><div><br></div><div>And when I run badblocks, there are way too many block errors. <br></div><div><br></div><div>The results are the same over the USB port, or when I dismember the disk <br></div><div>from its enclosure and connect it directly over SATA. <br></div></div>