<div dir="ltr"><div dir="ltr"><div>The disk is a run of the mill Fujitsu SATA laptop disk, 5400RPM.<br></div><div>It runs fine with no current issues. <br></div><div><br></div><div>[10211583.187902] usb 1-1.4: new high-speed USB device number 6 using dwc_otg<br>[10211583.318800] usb 1-1.4: New USB device found, idVendor=152d, idProduct=0539<br>[10211583.318813] usb 1-1.4: New USB device strings: Mfr=10, Product=11, SerialNumber=3<br>[10211583.318822] usb 1-1.4: Product: USB to ATA/ATAPI Bridge<br>[10211583.318830] usb 1-1.4: Manufacturer: JMicron<br>[10211583.318839] usb 1-1.4: SerialNumber: 00A1234568BF<br>[10211583.319682] usb-storage 1-1.4:1.0: USB Mass Storage device detected<br>[10211583.322659] scsi host0: usb-storage 1-1.4:1.0<br>[10211584.368515] scsi 0:0:0:0: Direct-Access     FUJITSU  zzzz        0100 PQ: 0 ANSI: 6<br>[10211584.369548] sd 0:0:0:0: [sda] 488397168 512-byte logical blocks: (250 GB/233 GiB)<br>[10211584.369929] sd 0:0:0:0: [sda] Write Protect is off<br>[10211584.369941] sd 0:0:0:0: [sda] Mode Sense: 67 00 10 08<br>[10211584.370348] sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, supports DPO and FUA<br>[10211584.433737]  sda: sda1 sda2 < sda5 ><br>[10211584.436222] sd 0:0:0:0: [sda] Attached SCSI disk<br>[10211848.858858] EXT4-fs (sda1): recovery complete<br>[10211848.858884] EXT4-fs (sda1): mounted filesystem with ordered data mode. Opts: (null)<br><br></div><div>There is the voltage warnings in dmesg on the Pi 2 (only a warning, no other ill effect), <br></div><div>but none of that on the Pi 3.</div><div><br></div><div>So there are no current issue, and a dock is not needed, or external power.</div><div><br></div><div>There is a noticeable delay though, around 400 milliseconds, when I try to list a directory that has not been accessed before. Perhaps it is spin up time? Or maybe file system delay (it is ext4) combined with the relatively slow Pi CPU. <br></div><div><br></div><div>What remains unanswered is how to partition the disk for Raspian, or to get NOOBS on it so I can install Raspian on it, then copy everything from the SD to the disk. <br></div></div></div>