<div dir="ltr"><div>Hello all ...<br><br>I have a project that drives two stepper motors. The motors have male plugs which are JST 2.0mm pitch PH 6-pin female. They look like the ones in the link below. <br><br></div><div>The motor seller included a female connector and tiny pins that go into it. A friend who has crimping tools was not able to put the pins in the connector, since they are so tiny. <br><br></div><div>Ordering from eBay would take 6 weeks or more. <br><br></div><div>Any idea where can I find these connectors with wires, or how to crimp them? <br><br></div><div><a href="https://www.ebay.ca/itm/10-Sets-Micro-JST-2-0mm-PH-6-Pin-Male-Female-Connector-Plug-With-Wire-300mm/352101794647">https://www.ebay.ca/itm/10-Sets-Micro-JST-2-0mm-PH-6-Pin-Male-Female-Connector-Plug-With-Wire-300mm/352101794647</a><br clear="all"><br></div><div>Some background in case you are wondering: this is a unipolar stepper motor with 6 wires. Only 4 will be connected, so as to drive it in half-coil mode. But it is not the same pin configuration that is comonly used for bipolar motors for 3D printers and CNCs, which uses full coil mode.<br><br></div><div>P.S. I am already checking with Computer Recycling, but doubt if they would have any.<br></div></div>