<div dir="ltr"><div class="gmail_default" style="font-family:tahoma,sans-serif">I have had very good luck getting oddball connectors and wiring harness bits here --</div><div class="gmail_default" style="font-family:tahoma,sans-serif"><br></div><div class="gmail_default" style="font-family:tahoma,sans-serif"><a href="https://www.yelp.ca/biz/orion-electronic-supplies-kitchener">https://www.yelp.ca/biz/orion-electronic-supplies-kitchener</a></div><div class="gmail_default" style="font-family:tahoma,sans-serif"><br></div><div class="gmail_default" style="font-family:tahoma,sans-serif">A trip would be required to the shop though as the staff is not terribly helpful tracking down a part even with an emailed pic.<br></div></div><div class="gmail_extra"><br clear="all"><div><div class="gmail_signature" data-smartmail="gmail_signature"><div dir="ltr"><div>Thanks,<br><br>Ron Singh<br><br></div></div></div></div>
<br><div class="gmail_quote">On Tue, Jun 26, 2018 at 12:34 PM, Khalid Baheyeldin <span dir="ltr"><<a href="mailto:kb@2bits.com" target="_blank">kb@2bits.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div dir="ltr"><div>Hello all ...<br><br>I have a project that drives two stepper motors. The motors have male plugs which are JST 2.0mm pitch PH 6-pin female. They look like the ones in the link below. <br><br></div><div>The motor seller included a female connector and tiny pins that go into it. A friend who has crimping tools was not able to put the pins in the connector, since they are so tiny. <br><br></div><div>Ordering from eBay would take 6 weeks or more. <br><br></div><div>Any idea where can I find these connectors with wires, or how to crimp them? <br><br></div><div><a href="https://www.ebay.ca/itm/10-Sets-Micro-JST-2-0mm-PH-6-Pin-Male-Female-Connector-Plug-With-Wire-300mm/352101794647" target="_blank">https://www.ebay.ca/itm/10-<wbr>Sets-Micro-JST-2-0mm-PH-6-Pin-<wbr>Male-Female-Connector-Plug-<wbr>With-Wire-300mm/352101794647</a><br clear="all"><br></div><div>Some background in case you are wondering: this is a unipolar stepper motor with 6 wires. Only 4 will be connected, so as to drive it in half-coil mode. But it is not the same pin configuration that is comonly used for bipolar motors for 3D printers and CNCs, which uses full coil mode.<br><br></div><div>P.S. I am already checking with Computer Recycling, but doubt if they would have any.<br></div></div>
<br>______________________________<wbr>_________________<br>
kwlug-disc mailing list<br>
<a href="mailto:kwlug-disc@kwlug.org">kwlug-disc@kwlug.org</a><br>
<a href="http://kwlug.org/mailman/listinfo/kwlug-disc_kwlug.org" rel="noreferrer" target="_blank">http://kwlug.org/mailman/<wbr>listinfo/kwlug-disc_kwlug.org</a><br>
<br></blockquote></div><br></div>