<div dir="ltr"><div><div><div><div>Yes, there are cables going up in various rooms (the joy of an unfinished basement), and they are all hidden from view.<br><br></div>The one I ended up using is the one that goes to the VoIP device. <br></div><br></div>The cable was plugged into the new router, and the VoIP device was plugged into another of the new router's LAN ports. <br><br></div>The next step is a small UPS so the VoIP device is UPS protected too. If you see one like the ones you bought, let me know.<br></div><div class="gmail_extra"><br><div class="gmail_quote">On Sun, Apr 2, 2017 at 12:14 PM, B.S. <span dir="ltr"><<a href="mailto:bs27975.2@gmail.com" target="_blank">bs27975.2@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">So you do / did have one ethernet cable to tap into above the basement. Must have missed that.<br>
<br>
<br>
JJ's post gave me a D'OH! moment within a few lines ...<br>
<br>
The (original) issue may not be the router getting out, but the much less powerful dongle getting back in.<div><div class="h5"><br>
<br>
<br>
On 04/02/2017 12:03 PM, Khalid Baheyeldin wrote:<br>
</div></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div><div class="h5">
Here is a followup on the issue.<br>
<br>
First regarding JJ's post. The issue is not 'reception'. The issue is<br>
'coverage', 'strength', and 'stability'. The backyard had some coverage,<br>
but it is weak and intermittent. Not a stable connection for what I want to<br>
do (basically control a camera connected to a telescope). The WiFi router<br>
is in the basement, and perhaps blocked by the concrete walls, and/or the I<br>
beams interfering. So the solution I had in mind from the beginning is to<br>
have another AP station upstairs closer to the back of the house, and<br>
higher up, rather than in the centre of the basement.<br>
<br>
Now for what ended up working for my case:<br>
<br>
I got another router, put OpenWRT 15.05.1 on it and connected it to an<br>
ethernet cable that runs from the basement (where the main router is). The<br>
connection is via one of the LAN ports, not the WAN port.<br>
<br>
I put a separate SSID on it, and gave it an address on the same subnet.<br>
<br>
Then disabled DHCP and the Firewall on it.<br>
<br>
The basic steps are under the Web LuCI section here:<br>
<br>
<a href="https://wiki.openwrt.org/doc/recipes/dumbap" rel="noreferrer" target="_blank">https://wiki.openwrt.org/doc/r<wbr>ecipes/dumbap</a><br>
<br>
The only thing that I added to the above steps is add the main router's IP<br>
as a default gateway.<br>
<br>
It works well. There is good coverage for the far end of backyard. And this<br>
is done without having to deal with outdoor cables, nor run a cable up and<br>
another down and move the main router to the main floor, and get a UPS for<br>
it.<br>
<br>
For the sake of completeness, I am listing other stuff that found on<br>
OpenWRT. None of them do what I want, but related in case someone needs it.<br>
<br>
There is a whole bunch of info in the recipes section of OpenWRT's wiki,<br>
with relayd, routed, bridged, ...etc. And there are limitations, ...etc.<br>
This may be helpful for other cases.<br>
<br>
<a href="https://wiki.openwrt.org/doc/recipes" rel="noreferrer" target="_blank">https://wiki.openwrt.org/doc/r<wbr>ecipes</a><br>
<br>
<br>
<br>
On Sun, Apr 2, 2017 at 11:02 AM, <<a href="mailto:jvj@golden.net" target="_blank">jvj@golden.net</a>> wrote:<br>
<br>
</div></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div><div class="h5">
All<br>
<br>
I have skimmed through the emails in this thread and am impressed and<br>
intrigued by the depth of the knowledge on this issue.<br>
However, for some of the newbies in the group/list I will mention a<br>
possible common error in the premise of the OP's original post.<br>
<br>
The OP starts out with "WiFi reception in my house ...".<br>
<br>
And herein in the error. (Or maybe not. )<br>
<br>
As with cell phones many use the term "reception" when referring to<br>
performance the device, e.g. cell phone, notebook, laptop, etc. They forget<br>
that there may be "reception" issues a the other end whether the other end<br>
is a wifi router or cell tower. The device is, after all, a two way<br>
instrument, both an RF receiver and a RF transmitter. RF signals are<br>
transmitted from the device and are received at the wifi router or cell<br>
tower.<br>
<br>
Efforts to increase the RF transmission signal strength at the wifi router<br>
to "increase range" will not address any problems of RF transmission at the<br>
device.<br>
<br>
There have been some good suggestions that may address issues with the<br>
two-way RF transmission/reception. One or more contributors mentioned<br>
relocating the router (with its antennae) and/or addressing any impediments<br>
in the environment which may serve to attenuate RF signals. At least one<br>
contributor mentioned repeaters or mesh networks.<br>
<br>
I will guess that there is not really much anyone can do with software in<br>
the wifi router to improve the two-way RF transmission/reception in the<br>
router or device for that matter. The RF modulation/demodulation is<br>
performed in the chip set and this may be locked into the chip set. Of<br>
course, chip set drivers may be available and may help.<br>
<br>
John Johnson<br>
With apologies to the OP.<br>
<br>
<br></div></div>
------------------------------<br>
*Subject:* [kwlug-disc] Extending WiFi Range<br>
*Date:* Wed, 29 Mar 2017 19:29:33 -0400<br>
*From:* Khalid Baheyeldin <<a href="mailto:kb@2bits.com" target="_blank">kb@2bits.com</a>><br>
*To:* KWLUG discussion <<a href="mailto:kwlug-disc@kwlug.org" target="_blank">kwlug-disc@kwlug.org</a>><br>
*Reply-To:* <a href="mailto:kb@2bits.com" target="_blank">kb@2bits.com</a>, KWLUG discussion <<a href="mailto:kwlug-disc@kwlug.org" target="_blank">kwlug-disc@kwlug.org</a>><span class=""><br>
<br>
WiFi reception in my house, using the OpenWRT powered D-Link DIR-835, is<br>
generally adequate, but could be better in some spots. Reception is<br>
intermittent in the backyard, where I am pondering a project that would<br>
need it. Perhaps the basement's concrete is interfering?<br>
<br>
I like OpenWRT and plan to stay with it. Also the router itself has lots<br>
of storage (flash) and RAM, so will be here for the future. It is in the<br>
basement, near the cable modem, and other equipment, and connected to the<br>
UPS in there.<br>
<br>
Moving it to the main floor is not likely since it would involve finding a<br>
power outlet and running Ethernet, as well as losing the UPS connection.<br>
<br>
So, my questions are:<br>
<br>
1. What does one do in this case? Do you buy another router, possibly one<br>
capable of running OpenWRT and turn off the router features, and keep it<br>
only as a WiFi hotspot and put it near the spots where good reception is<br>
needed?<br>
<br>
2. If so, what are good routers that you tried this on?<br>
<br>
3. How did you turn off OpenWRT routing ...etc. on it?<br>
<br>
4. Does the new WiFi hotspot have its own SSID or can it use the same SSID<br>
as the main router?<br>
<br>
Any other thoughts/ideas welcome.<br>
</span></blockquote></blockquote>
<br><div class="HOEnZb"><div class="h5">
______________________________<wbr>_________________<br>
kwlug-disc mailing list<br>
<a href="mailto:kwlug-disc@kwlug.org" target="_blank">kwlug-disc@kwlug.org</a><br>
<a href="http://kwlug.org/mailman/listinfo/kwlug-disc_kwlug.org" rel="noreferrer" target="_blank">http://kwlug.org/mailman/listi<wbr>nfo/kwlug-disc_kwlug.org</a><br>
</div></div></blockquote></div><br><br clear="all"><br>-- <br><div class="gmail_signature" data-smartmail="gmail_signature">Khalid M. Baheyeldin<br><a href="http://2bits.com" target="_blank">2bits.com</a>, Inc.<br>Fast Reliable Drupal<br>Drupal optimization, development, customization and consulting.<br>Simplicity is prerequisite for reliability. --  Edsger W.Dijkstra<br>Simplicity is the ultimate sophistication. --   Leonardo da Vinci<br>For every complex problem, there is an answer that is clear, simple, and wrong." -- H.L. Mencken<br></div>
</div>