So, I am singing the praises for Kubuntu 9.10 (Karmic Koala) after I upgraded on Saturday.<br><br>Then, I grab another laptop and try to do the same upgrade that I did on mine, but reach a dead end.<br><br>What happens is that the system never booted fully after the upgrade.<br>

<br>Getting into grub and running safe mode, shows the following messages:<br><br>-----------<br>Begin: Loading essential drivers ...<br>Done.<br>Begin: Running /scripts/init-premount ...<br>Done.<br>Begin: Mounting root file system ...<br>
Begin: Running /scripts/local-top ...<br>Done.<br>Begin: Running /scripts/local-premount ...<br>[   3.710938] PM: Starting manual resume from disk<br>Done.<br>[   3.728858] kjournald starting. Commit interval 5 seconds<br>
[   3.728942] EXT3-fs: mounted filesystem with ordered data mode.<br>Begin: Running /scripts/local-bottom ...<br>Done.<br>Done.<br>Begin: Running /scripts/init-botton ...<br>Done.<br>mount: can't find /home/public in /etc/fstab or /etc/mtab<br>
-----------<br><br>That is it: no login prompt, no command prompt, no GUI. It just hangs there.<br>No Alt-F1, Alt-F2 prompts either.<br>
<br>Pressing Ctrl-Alt-Del reboots the machine successfully, but that is the only<br>thing I can do. <br><br>Going into grub and editing the boot line to add "noresume acpi=off single" does<br>not help. It just stops at the same place.<br>

<br>Not sure if the system is hung up on an old hibernated image that has these<br>things, and getting stuck on something. I say that because it tries to mount NFS shares that are commented out in /etc/fstab.<br><br>How do I make sure that it is a clean boot without attempting to load a hibernated<br>

image from the swap area?<br><br>I am able to change the grub command line to " ... rw init=/bin/bash", and get a prompt. I connected the ethernet cable, got an IP address, and ran aptitude update && aptitude full-upgrade and made sure there are no pending updates.<br>
<br>I regenrated the initrd image using update-initramfs -k all -c, and ran update-grub as well. No go still ...<br><br>Searching Google shows that others have reported the same symptom (/scripts/init-bottom), but normally it was an incomplete upgrade. I completed the upgrade but still have the same hang.<br>

<br>I thought about backing up the home directory and doing a clean install, but USB disks are not automatically recognized when I boot with init=/bin/bash.<br><br>Any ideas?<br>-- <br>Khalid M. Baheyeldin<br><a href="http://2bits.com" target="_blank">2bits.com</a>, Inc.<br>
<a href="http://2bits.com" target="_blank">http://2bits.com</a><br>Drupal optimization, development, customization and consulting.<br>Simplicity is prerequisite for reliability. --  Edsger W.Dijkstra<br>
Simplicity is the ultimate sophistication. --   Leonardo da Vinci<br>